Smart Light Conversion using ESP8266 and a Relay Circuit Diagram

Smart Light Conversion using ESP8266 and a Relay Circuit Diagram It includes firmware which runs on the low cost Wi-Fi enabled ESP8266 Wi-Fi SoC from Espressif Systems, and hardware which is based on the ESP-12 module. It has GPIO, SPI, I2C, ADC, PWM AND UART pins for communication and controlling other peripherals attached to it. Circuit diagram for this IoT based Smart Street Light is as follows: This At the moment, street lamps control much of the urban environment only through manual control, via a control switch installed in each street lamp. A significant amount of electrical energy is lost. So we have created a solution for that problem which is an automatic street light only using NodeMCU, LDR sensor and IR sensor. Automatic Brightness Adjustment: Street lights adjust their brightness levels based on ambient light conditions, ensuring optimal illumination at all times.; Motion Detection: Lights change brightness when motion is detected in the vicinity, enhancing security and safety for pedestrians and motorists.; Energy Efficiency: By intelligently managing lighting schedules and brightness levels, the

immediately identifies it and increases the light intensity. As soon as the vehicle travels away from the sensor, the intensity of the taillight is reduced. And using the ESP8266 Module the traffic in the area can be saved regularly and the system can use this data to stay at . high intensity during those times. Both manually and automatically

vanshsethi23/Smart Circuit Diagram

The proposed IoT based system provide a solution for energy saving. We use IR sensor, Light Intensity sensor and NodeMCU (ESP8266) board to design an intelligent system. We use IR sensor for detecting vehicles on the road, Light sensor for detecting light intensity. Based on vehicles present on the road and light intensity, we control street

The main goal of this project is to create a smart street light system using IoT technology to reduce energy consumption, increase efficiency, and optimize p

Smart Street Light Using NodeMCU and IOT ThingSpeak Circuit Diagram

This document discusses a project to develop an IOT based smart street light system using Arduino, ESP8266 Node MCU Wi-Fi module, infrared sensor, and light dependent resistor. The system allows automatic switching of street lights based on ambient light levels and movement detection to save energy. It provides advantages over regular street light systems like being automatic, low maintenance